Filter
Top Products
-20-
G0462 Wood Lathe (Mfd. Since 11/14)
To pivot the headstock:
1. DISCONNECT LATHE FROM POWER!
2. Make sure the head lock lever is tight.
3. Pull the pivot lock pin out (see Figure 17) and
pivot the headstock clockwise 90˚ or 180˚, as
shown in Figure 18.
The tailstock is equipped with a cam-action
clamping system to secure it. When the lock lever
is tightened, a locking plate lifts up and secures
the tool rest to the bed.
To reposition the tailstock along the bed, loosen
the tailstock lock lever (see Figure 19), move the
tailstock to the desired position, then retighten the
lock lever.
Note: If the lock lever does not securely clamp the
tailstock down onto the bed, loosen or tighten the
hex nut located on the underside of the tailstock in
small increments to achieve the proper clamping
pressure.
Adjusting Tailstock
Position
4. Release the pivot lock pin. Make sure the pin
has engaged in its detent by trying to rotate
the headstock.
Figure 17. Pivot lock pin location.
Head
Lock Lever
Pivot
Lock Pin
Figure 18. Head set at 90˚ and 180˚.
Figure 19. Tailstock lock lever.
Tailstock
Lock Lever