Filter
Top Products
G0562 3 HP Dust Collector -15-
Components and Hardware Needed: Qty
Collector Rings (R & L) ......................................2
Flange Bolts
5
⁄16"-18 x
1
⁄2"..................................20
Rubber Gaskets ................................................2
Tools Needed:
Wrench or Socket 12mm....................................1
To install the collector:
1. Place one of the rubber gaskets around the
rim of the intake on the collector ring.
2. Secure one of the collector rings to the metal
“Y” outlet with 8 flange bolts (Figure 12).
Collector Ring
Figure 12. Collector ring installed.
Figure 13. Collector rings installed.
Canister Filter
Components and Hardware Needed: Qty
Canister Filters ..................................................2
Canister Filter Cleaning Handles ......................2
Metal Belt Clamps ..............................................2
Wide Foam Strips ..............................................2
Tools Needed:
Wrench or Socket 10mm....................................1
To install the canister:
1. Secure the wide foam strip around the out-
side top rim of the collector ring as shown in
Figure 14.
Figure 14. Installing wide foam strip.
3. Attach the canister support to the side of the
collector ring with the 2 remaining flange
bolts.
4. Repeat steps 1-3 for the other collector ring
(Figure 13).