Filter
Top Products
-22- G0562 3 HP Dust Collector
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
Turn on the power supply at the main panel.
Press the START button. Make sure that your fin-
ger is poised on the STOP button, just in case
there is a problem. The dust collector should run
smoothly, with little or no vibration or rubbing
noises. Strange or unnatural noises should be
investigated and corrected before operating the
machine further.
If you cannot easily locate the source of an
unusual noise or vibration, contact our service
department for help.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
Wear safety glasses
during the entire opera-
tions process. Failure to
comply may result in
serious personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Operating your Model G0562 is simple and
straightforward. Blast gates located at each of
the machines controls the air flow from the wood-
working machine to the dust collector. If a
machine is not being used, keep the blast gate
closed to maintain higher levels of efficiency
throughout the system.
Always wear a respira-
tor when operating your
dust collector. This
machine circulates saw-
dust which may cause
allergic reactions or res-
piratory problems.
DO NOT use the dust collector for any
other purpose besides collecting dust
from connected woodworking machines.
A dust collector should NEVER be used as
an air cleaner. For safest use, wear a res-
pirator and use an air cleaner in addition to
the dust collector.
General
Test Run
SECTION 7: OPERATION