Filter
Top Products
OPERATIONS
-18-
To perform a standard scroll cutting opera-
tion:
For standard scroll cutting, follow the pattern
lines on the workpiece by pushing and turning
the workpiece at the same time. DO NOT turn
the workpiece without pushing it at the same
time; otherwise, the blade could twist and
break.
Interior Scroll
Cutting
Standard Scroll
Cutting
The scroll saw can also make internal scroll cuts
without having to cut through the perimeter of
the workpiece.
To perform an interior scroll cutting opera-
tion:
1. UNPLUG THE SCROLL SAW!
2. Remove the saw blade.
3. Drill a
1
⁄4" hole in the workpiece.
4. Place the hole in the workpiece over the
blade hole in the table insert.
5. Re-install the blade by sliding the bottom
end of the blade through the workpiece
hole. Note—If a plain end blade is being
used, the lower blade adapter may need to
be installed after the blade is slid through
the workpiece.
6. Adjust the drop foot onto the surface of the
workpiece.
7. Plug the scroll saw in and perform the cut-
ting operation.
8. When the cutting operation is complete,
unplug the scroll saw and remove the saw
blade.