Filter
Top Products
Router Installation
To install a router:
1.
2.
Figure 19
Note: To properly position the hold-down
clamp, adjust the tightness of the hold-down
knob and the adjustment bolt so that the
clamp will allow room for the router base in
the next step. If necessary, put the adjust-
ment bolt jam nut on the other side of the
clamp.
Figure 19.
If the router unexpectedly moves or the rout-
er bit contacts the table insert or fence dur-
ing operation, serious personal injury could
result from flying debris. ALWAYS make sure
that all four router clamps are used and are
applied to the flat surface of the router base
before connecting the router to power.
3.
Figure 20
4.
Figure 20.
NOTICE
To prevent dam-
age to the router
table T-slots, do not
position the clamp
adjustment bolts
over the thin edge of
the T-slots.