Grizzly T10222 Router User Manual


  Open as PDF
of 28
 


7. 
      
        


Important: The operator is very careful to
keep the workpiece firmly against the table
and fence during the entire cut.
8. 
Workpiece
Inspection
        
     

 Material Type:
     
  
      

 Foreign Objects:    
      
      
   

      
       

 Large/Loose Knots:   
     
     
      
     

 Wet or "Green" Stock:



 Excessive Warping:

       


      

 Minor Warping:
       
        
  


NOTICE
If you are using a mobile base with the table
saw, use one of the options below when
moving the saw and the router table attach-
ment:
• Attach an extension to the mobile base
that will provide support for the router
table leg.
• Install a locking caster onto the bottom
of the router table leg.
• Adjust the router table leg foot up,
move the unit, then re-adjust the foot
to provide proper support to the router
table.
 previous next