Filter
Top Products
MOUNTING
Step 1:Bolt the Slip Roll to a secure work surface using the four holes in the BASE (#25).
Step 2:You must purchase your own hardware. Buy four 5/16” bolts, nuts and lock washers,
and eight washers. Add 1” to the thickness of your workbench to determine the
appropriate length of your bolts.
Step 3:Place the Slip Roll in the desired location, making sure that there is enough room for
the handle (positioned on the right when looking from the front) to be moved. Make
sure there is enough room behind the Roll to accommodate stock.
Step 4:Mark the bench through the holes in the BASE.
Step 5:Remove Slip Roll.
Step 6:Drill 11/32” holes in the workbench.
Step 7:Place the Slip Roll so the holes in the BASE line up with the drilled holes.
Step 8:Install hardware in the following order:
A. Bolt
B. Slip Roll
C. Workbench
D. Washer
E. Lock Washer
F. Washer
G. Nut
Page 4 -- SKU 36698