Filter
Top Products
Page 17SKU 3733 For technical questions, please call 1-800-444-3353.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, loose or worn out blade, and
any other condition that may affect its
safe operation.
AFTER USE,2. clean external surfaces
of the tool with clean cloth. Drain wa-
ter from the water tray and wash out
any residue from the recessed pump
sump area.
Tool service must be performed 3.
only by qualied repair personnel.
Service or maintenance performed by
unqualied personnel could result in
a risk of injury.
When servicing a tool, use only 4.
identical replacement parts. Fol-
low instructions in the “Inspec-
tion, Maintenance, And Cleaning”
section of this manual. Use of
unauthorized parts or failure to follow
maintenance instructions may create
a risk of electric shock or injury.
5. WARNING! If the supply cord of
this power tool is damaged, it must
be replaced only by a qualied
service technician.
To clean: 6. Wipe with a damp cloth,
vacuum or use compressed air. Do
not use solvents.
When storing: 7. Store Tile Saw in a
safe, clean, dry, location out of reach
of children.
CAUTION! 8. All maintenance, service,
or repairs not listed in this manual are
only to be attempted by a qualied
service technician.
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start
No power at outlet.1.
Cord not connected.2.
Check power at outlet.1.
Check that cord is plugged in.2.
Blade spins slowly
Arbor shaft binding1.
Motor brushes worn2.
Check shaft for free spinning1.
Replace brushes2.
Excessive vibration Bent or off-balance blade1.
Bent Arbor Shaft2.
Replace blade with new one1.
Check shaft for run-out2.
Running hot;
excess smoke
Water ow problem.1.
Not enough water2.
Running with hot/warm water3.
Check connection1.
Add proper amount of water2.
Always run with cold water3.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.