Filter
Top Products
Page 6 For technical questions, please call 1-800-444-3353. Item 38142
Specifications
Motor Power 3/4 HP - 16 speeds ranging from 220 to 3600 RPM
Electrical Rating 120V~, 60Hz, 7.5A, Single-Phase
Drill Chuck Capacity 7/64″ to 5/8″
Spindle Stroke 3-1/8″
Swing 13-1/4″
Column Diameter 2- 57/64″
Dry Table 11-1/2″ Diameter
Table Slot 1/2″
Overall Height 41-3/4″
Weight 110 lbs.
Product Use For heavy-duty use on metal, plastic or wood materials.
Table rotates 360º and tilts 0-45º in 1º increments.
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level,
solid workbench capable of supporting the
weight of the drill press and any workpieces.
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
Assembly
Column Assembly to Base
1. With the Base (6B) on a flat level surface,
bolt on the Column Support (4B) using the
four M10x40mm Hex Head screws (5B).
2. Tighten firmly.
3. Insert the Column (1B) into its Support (4B) and
firmly secure with the Hex socket set screws (3B).
Note: It may be necessary to screw out the set
screws beforehand, as they may protrude into the
tube preventing the column from sliding in fully.
SAFETY OPERATION MAINTENANCESETUP