Filter
Top Products
# 41213 5
Wool Bonnet (Two Provided)
Warning!! Never mount a grinding wheel and use as a disc grinder.
OPERATION
15 to 25 Degrees
Side Handle (#34)
Always hold the Right Handle (#21) and the Side Handle (#34) firmly when operating the
tool. Use Wool Bonnet with a small amount of polishing compound or car wax. Do not put a
lot of pressure on the polishing disc. Too much pressure will result in a poor finish and will
possibly overload the motor. The weight of the polisher itself is sufficient.
Do not wax or polish a car in the direct sunlight. Work in a shaded area.
To use this tool as a sander refer to Figure 1 under ASSEMBLY directions on page four.
Follow the same directions, substituting the Sanding Disc for the Polishing Wheel (#46).
Do not use the entire Sanding Disc surface on the workpeice. The inner edge of the
disc should be used at a 15 to 25 degree angle as shown in Figure 3. Let the tool do the job
for you. Excessive pressure will result in uneven surfaces and could damage the motor.
Sanding Discs can be purchased at Harbor Freight Tools.
Right Handle (#21)
Figure 2
Figure 3