Filter
Top Products
SKU 42307 For technical questions, please call 1-800-444-3353. Page 7
SPECIFICATIONS
Arbor 3/8”
Blade 2” HSS
Power Source 120 V~, 60 Hz, .9 A
Max. RPM 7800
Cutting Depth 3/4”
Miter Gauge 0°- 45°
Base 5-1/2” L X 5” W
Overall 9” Length X 5-1/2” W X 6-3/4” H
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
ASSEMBLY
Your Mini Cut-Off Saw will require
some assembly. Information on installa-
tion is included below for your reference.
For assistance with assembly please refer
to the illustration in the operation section
as well as the Assembly diagram and the
Parts List near the end of this manual.
It is important that you read the entire
manual to become familiar with the unit
BEFORE you use it. Be sure that you
have all parts described in the Parts List.
The Mini Cut-Off Saw can be mount-
ed to your table or workbench with four
(4) 1/8” Bolts (not included). Insert a Bolt
through the hole in each corner and tight-
en it into place with a Nut (not included).
The mounting surface must be at, level
and capable of supporting the weight of
the Saw combined with the materials to
be cut. The Saw can also be mounted by
securing the top of the Clamp (24) into its
slot (See Assembly Diagram) and tighten-
ing the bottom of the clamp to the desired
work surface.
Installing the Cutting Blade
With the tool OFF and Unplugged, 1.
slide the Blade Guard (21) up and off
of the Saw.
Insert the HSS Saw Blade (18) onto 2.
the Arbor (16). Slide on the Washer
(19) and then tighten on the Screw
(20). Slide the Blade Guard (21)
back on.
WARNING! Mount the blade so that its ar-
row matches the arrow on the Blade
Guard (21).
Replacing the Timing Belt
Slide the Belt Cover (7) up to remove 1.
it from the Saw. This will expose the
Timing Belt (5) and the Driving Pul-
leys (12 and 4).
Slide the one end of the Timing Belt 2.
(5) over the Driving Pulley (4). Once
this side is in place, side the other
end of the Timing Belt (5) over the
Driving Pulley (12).
Make certain that the Timing Belt (5) 3.
is centered on both Driving Pulleys
(12 & 4). Replace the Belt Cover (7)
by sliding it back down into place.