Filter
Top Products
SKU 42307 For technical questions, please call 1-800-444-3353. Page 8
OPERATION
When operating your Mini Cut-Off
Saw, it will be helpful to refer to Figure 1
as well as to the Parts List and Assembly
Diagram near the end of this manual.
Setting the Vise
The Miter Gauge on the Vise (9) can 1.
be set from 0°- 45°. Loosen the Vise
Fixture (22) and slide the Gauge to
the desired angle. Tighten the Vise
Fixture into place.
The Vise Jaw (25) can be adjusted 2.
for the work piece with the Vise
Handle (11). Turning the Vise Handle
(11) clockwise will tighten the Vise
Jaw(s) onto the workpiece. Turning
the Vise Handle counterclockwise will
loosen the Vise Jaw.
Cutting
Place the material to be cut in the 1.
Vise (9) as described above.
The Mini Cut-Off Saw has a Safety 2.
Lever (27) which must be released to
lower the Blade. Pushing down on
the Safety Lever (27) will release the
Safety Lever, allowing you to push
down on the Handle (8) to begin cut-
ting.
Turn the Saw “ON” by pressing down 3.
on the red Switch (6) on the side
marked with —. To turn the Saw
“Off”, press down on the end of the
Switch (6) marked O.
With the Saw at full speed, move it 4.
slowly forward to complete the cut.
When the cut is complete, pull up on 5.
the Handle (8). The Safety Lever
(27) will engage. Turn the Saw “Off”.
Store out of reach of children.6.
Belt Cover (7)
Switch (6)
Safety
Lever (27)
Handle (8)
Vise Fixture (22)
Blade Guard (21)
Arrow on Blade Guard
Vise Handle (11)
Mounting Holes
Vise Jaw (25)
Figure 1
REV 10a