Filter
Top Products
Page 3For technical questions, please call 1-800-444-3353.SKU 45689
Rev 02/02
8. DO NOT OVERREACH. Keep proper footing and balance at all times to prevent tripping,
falling, back injury, etcetera.
9. STAY ALERT. Watch what you are doing at all times. Use common sense. Do not use this
product when you are tired or distracted from the job at hand.
10. CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will
operate properly and perform its intended function. Check for damaged parts and any other
conditions that may affect the operation of this product. Replace or repair damaged or worn
parts immediately.
11. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts. Only use accessories intended for use with this product. Approved
accessories are available from Harbor Freight Tools.
12. MAINTAIN THIS PRODUCT WITH CARE. Keep this tool clean and dry.
13. MAINTENANCE: For your safety, service and maintenance should be performed regularly
by a qualied technician.
14. USE THE RIGHT PRODUCT FOR THE RIGHT JOB. There are certain applications for
which this product was designed. Do not use small equipment, tools or attachments to do
the work of larger industrial equipment, tools or attachments. Do not use this product for a
purpose for which it was not intended.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. GROUND THIS PRODUCT. The supplied electrical Power Cord Plug for this product
is a grounded, 115 Volt, 3-Prong Plug. Never remove the grounding prong or modify the
Plug in any way. Do not use adapter plugs with this product. When in use, make sure this
product is always plugged into a grounded, 115 Volt, 3-hole electrical receptacle with an
appropriate breaker switch inline.
2. MAKE SURE THE CONTROL SWITCH (part #25) IS IN THE “OFF” POSITION BEFORE
PLUGGING IN THE POWER CORD. (See Figure D, and Assy. Diagram.)
3. DO NOT ABUSE THE POWER CORD. Do not use the Cord to pull the 3-Prong Plug from
a power outlet. Keep Cord away from heat, oil, sharp edges, and moving parts. Replace
damaged Cord immediately. Route the Power Cord safely. Protect it from being damaged
by other equipment in the shop. Do not route the Cord where it can be walked on or tripped
over.
4. MAINTAIN A SAFE WORK ENVIRONMENT. Do not use this product in or near damp or
wet areas. Do not expose this product to rain. Keep work area well lit. Make sure there is
adequate surrounding work space. Use this product in a well ventilated area. (Read Material
Safety Data Sheets/MSDS for metals, coatings, and cleaners.) Do not operate this product