Filter
Top Products
Page 2SKU 45707 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS TABLE
Electrical Requirements 120V / 60 Hz / 1/3HP / 3,600 RPM Motor
Maximum Stock Capacity 3/4”
Maximum Grinding Diameter 1”
Taper Angle 0-180 Degrees
Relief Angle 0-45 Degrees
Negative Angle 0-26 Degrees
Grinding Wheel Size 4” Diameter x 2” Deep x 3/4” Thick
Light Source Built-In Lamp – 12V, 35 Watts
Weight 92.5 lb.
Note: Additional operating instructions and user information is available in the backup
Operating Handbook included with this product. Please read and understand this
instruction manual and the backup Operating Handbook before using the Univer-
sal Cutter/Grinder.
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, operating and
maintenance procedures, parts list and diagram. Keep your invoice with this manual.
Write the invoice number on the inside of the front cover. Keep this manual and invoice
in a safe and dry place for future reference.
SAFETY WARNINGS AND PRECAUTIONS
KEEP WORK AREA CLEAN AND DRY. Cluttered, damp or wet work areas
invite injuries.
KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle
this product.
STORE IDLE EQUIPMENT. When not in use, tools and equipment should be
stored in a dry location to inhibit rust. Always lock up tools and equipment and
keep out of reach of children.
DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR
DRUGS. Read warning labels on prescriptions to determine if your judgement or
reexes are impaired while taking drugs. If there is any doubt, do not attempt to
use this tool.
USE EYE AND HEARING PROTECTION. Wear ANSI approved safety impact
eye glasses with an ANSI approved full face mask. Also, wear ANSI approved
hearing protectors when working with this product. ANSI approved safety impact
eye glasses, full face mask, and hearing protectors are available from Harbor
Freight Tools.
1.
2.
3.
4.
5.
REV 02b