Filter
Top Products
SKU 47016 For technical questions, please call 1-800-444-3353. Page 5
Assembly
Refer to Assembly Drawing on page 9.
1. To attach the Cup (#19), screw it onto the Connector (#43).
2. Screw the Air Connector (#40) into the bottom of the Body (#13).
Operation
Warning! Never allow the Spray Gun and Cup (#19) to lay on it’s side when the Cup (#19) is
full of paint.
Spray
Gun
For best service, you should incorporate an oiler, a regulator, and an inline air filter, as shown
above. All are available at Harbor Freight Tools.
Note: It is recommended that you test the Spray Gun on scrap material, to become familiar
with the available adjustments, prior to use.
1. Remove the Lid (#23) on the Cup (#19) and add no more than 10 ounces of paint.
Replace the Lid (#23).
2. Connect the air hose to the Air Connector (#40) and set the pressure to 50 PSI. Do
not exceed 70 PSI.
3. Squeeze the Trigger (#31) to test the pattern.
4. Spray from a distance of approximately four to eight inches while keeping the Spray
Gun perpendicular to the ground.
5. Maintain your distance as you evenly move from side to side. Do not fan or arc the
Spray Gun or the paint will apply unevenly.
6. When you finish spraying, release the Trigger (#31), and disconnect the air hose.
7. Empty the Cup (#19). Never store the Cup (#19) with paint in it.
Warning! Even after the compressor is shut down, the Cup (#19) may still be pressurized.
Open it slowly and carefully.
Adjustments
1. You can fine tune the air pressure by slowly turning the Air Adjustment Screw Valve
Assy. (#A5). You may also adjust the pressure with the air compressor. Make sure
you do not exceed the recommended 70 PSI.
2. You can adjust the amount of fluid coming through the gun with the Fluid Control
Knob (#18). Loosen the Fluid Control Knob Lock (#17), make the adjustment, and
tighten the Fluid Control Knob Lock (#17).
Warning! Keep your hand away from the Trigger (#31) while adjusting jet shape.
3. To adjust the spray pattern, turn the Air Cap (#3).