Filter
Top Products
Figure 2
Grip (#28)
Washer (#19)
Hex Nut (#18)
Hex Bolt (#29)
Washer (#19)
Hex Nut (#18)
Step 5) Through the center hole in the extension, insert Hex Bolt (#29), slide on Washer
(#19) and fasten with Nut (#18)-see Figure 2.
Step 6) Set the U-Frame Channel (#10) on top of the Right Leg Stand Frame (#27) as shown
in Figure 2. Attach the U-Frame Channel (#10) to the Right Leg Stand Frame (#27)
with Cross Head Bolt (#16); slide on Washer (#15) and tighten on Hex Nut (#14)-see
Figure 2.
Step 7) Attach the Left Leg Frame Stand (#26) extension to the U-Frame Channel (#10).
First, hold the Spacer 22 mm (#9) between the Left Leg Frame Stand (#26) and the
U-Frame Channel (#10), then insert the Cross Head Bolt (#8) through Left Leg
Frame Stand (#26) through Spacer (#9) and through U-Frame Channel (#10). Slide
on Washer (#15) and Nut (#14)-refer to Figure 3.
U-Frame Channel (#10)
Cross Head Bolt (#16)
Washer (#15) with Hex Nut (#14)
Left Leg Frame Stand (#26)
U-Frame Channel (#10)
Spacer (#9)
Cross Head Bolt (#8)
Washer (#15) and Nut (#14)
Figure 3
Step 8) On the underside of the U-Frame Channel (#10), insert the Sliding Locking
Block (#13) with Spring (#12) (see Figure 4) and Check Pawl (#11). On the top of
the U-Frame Channel, set the Connecting Part (#7).
Figure 4
Spring (#12)
Sliding Locking
Block (#13)
#47078 Page 4