Filter
Top Products
Step 9) Lay the Table Top Back (#6) on top of the Connecting Parts (#7). Through the inside
hole, insert Cross Head Bolt (#3) with Washer (#4) so that it threads down through
the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking
Block (#13).
Step 10) Through the outside holes in the Table Top Back (#6), thread the Push Button (#2)
into the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking
Block (#12).
Step 11) Lay the TableTop (front) (#23) onto the Threaded Sliding Blocks (#21) which are set
in place on the U-Frame Channel (#10). Screw in Cross Head Bolt (#22) with
Washer (#4) through the Table Top (front) and into the Threaded Sliding Blocks (#21).
Step 12) As necessary, attach Rubber Feet (#30) to each Leg Stand Frame.
Operation
The Quick Action 8-Position Workbench folds for easy travel and storage.
Step 1) The Table Top (front) (#23) can be moved by turning the Handles on the U-Frame
Channel (#10). Turning the Handle clockwise will move the Table Top in towards the
other Table Top. Turning the Handle counterclockwise will move the Table
Top (front) (#23) out.
Step 2) Pressing on the red Push Buttons (#2) with your thumb allows you to grasp the Table
Top (back) (#6) with your hands and fingers and slide it forward or backward while
the Push Buttons (#2) are pressed down. Releasing the Push Buttons (#2) will lock
the Table into place-see Figure 5.
Step 3) The Swivel Pegs (#1) and Peg Supports (#5) can be placed into any hole in the Work
Table top provide a block to secure and block your workpiece.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
Figure 5
#47078
Page 5