Filter
Top Products
2. USE ONLY CLEAN, DRY, REGULATED, COMPRESSED AIR AT BETWEEN 60
TO 115 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other
bottled gas as a power source for this tool.
3. NOTE: An air compressor is not provided. You will need an air compressor with
a minimum rating of 4 to 6 CFM delivery at 90 PSI.
4. WHEN CONNECTING TO THE AIR SUPPLY: Prior to each use, if an automatic
oiler is not used, add two drops of Air Tool Oil (part #95) into the Air Plug
(part #33) of the Air Stapler. Attach the air compressor hose to the Air Plug. Turn
on the air compressor, and set the regulator to the recommended 60 to 115 PSI
for this tool. (See Figure A.)
TO
AIR
COMPRESSOR
TO
AIR
STAPLER
PSI AIR REGULATOR
ADJUST
FROM
60 PSI TO 115 PSI
FIGURE A
SKU 54425 PAGE 4
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. IMPORTANT CONSUMER INFORMATION: This Air Stapler is equipped with a
Contact Trip Trigger. This Trigger mechanism is designed primarily for high
volume work where exact placement of the Staple is not critical. By holding the
Trigger, the Air Stapler will fire each time the nosepiece contacts the wood. A
characteristic of this design is the tendency to “double-fire” if used to shoot one
Staple at a time. This can be caused by the recoil produced and lingering finger
pressure on the Trigger. To avoid this occurrence, hold the Air Stapler firmly
against the wood and give the Trigger one quick squeeze. A single shot Air
Stapler, equipped with a sequential Trip Trigger, may be considered if high vol-
ume, rapid stapling is not required. This Air Stapler should give the owner long,
dependable service. However, failure to understand its operating characteristics,
or careless use, can result in property damage or serious personal injury.