Filter
Top Products
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed on the following pages, refer to the
Assembly Diagram on page 10.
To Attach A Quick Connector To The Air Stapler:
1. The Air Stapler requires the attachment of a 1/4”-18 NPT Quick Connector (not
included) to the Air Plug (part #33) of the Air Stapler. To do so, wrap the
threaded portion of the Quick Connector with about 3” of pipe thread seal tape
(not included). Then, wrench tighten the Quick Connector into the Air Plug
(See Figure B.)
SKU 54425 PAGE 6
OPERATING INSTRUCTIONS
To Prepare The Air Stapler For Use:
1. CAUTION: Make sure to keep the Air Stapler pointed away from you
and others at all times. Always disconnect the Air Stapler to its air supply
before loading nails. Do not load nails with the Trigger (part #31) or
Safety Element (part #55) depressed. (See Figure C, next page.)
2. Lift the Magazine Latch (part #39) up, and pull the Moving Rail (part #76) all the
way to the rear until it latches. (See Figure C.)
3. Orient a strip of Staples with the points down, and drop the strip of Staples into
the Moving Rail (part #76). (See Figure C.)
AIR PLUG (#33)
QUICK CONNECTOR
(NOT INCLUDED)
WRAP THREADED PORTION
WITH 3” PIPE THREAD SEAL
(NOT INCLUDED)
FIGURE B
SAFETY ELEMENT (#55)
TRIGGER
(#31)
NOSE