Filter
Top Products
Page 11For technical questions, please call 1-800-444-3353.Item 60238
General Operating Instructions
1. Bring the drill bit down with the Feed Knob to where
the hole is to be drilled.
Make minor workpiece alignment adjustments.
2. Plug the Power Cord into an electrical outlet.
3. Turn the Drill Press on.
4. Pull down on the Feed Knob and slowly
drill the hole into the workpiece.
WARNING! If the drill bit grabs and spins the workpiece,
do not attempt to stop the spinning with your hands.
Step back, and turn the drill press off. Wait for the
spindle to stop turning before dislodging the workpiece.
5. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
SAFETYOPERATIONMAINTENANCE SETUP