Filter
Top Products
Page 6 For technical questions, please call 1-800-444-3353. Item 60238
Specifications
Electrical Rating 120V~ / 60Hz / 2.4A
Spindle Speeds
760, 1150, 1630, 2180, 3070 RPM
5 Speeds
Table Tilt 45º left and right
Swing 8"
Spindle Stroke 2"
Spindle Taper B16
Chuck Capacity 1/16″ - 1/2″ (13mm)
Worklight Bulb Size E14 base, 120V, 15W
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level,
solid workbench capable of supporting the
weight of the drill press and any workpieces.
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
Assembly
Column to Base
1. Place Column (8) on the Base (1) and align
holes in the Column with holes in the Base.
2. Attach using Bolt (5), Spring Washer (4),
and Washer (3) in each hole through
the Column and into the Base.
Column (8)
Bolt (5)
Base (1)
Figure A: Column to Base Connection
227541
SAFETY OPERATION MAINTENANCESETUP