Filter
Top Products
Page 4SKU 06098
If there is any doubt, do not operate the tool.
19. Maintenance. For your safety, service and maintenance should be performed regularly
by a qualified technician.
20. Use proper size and type extension cord. If an extension cord is required, it must be of
the proper size and type to supply the correct current to the tool without heating up.
Otherwise, the extension cord could melt and catch fire, or cause electrical damage to
the tool. This tool requires use of an 120 VAC extension cord of 20 amps minimum
capability (up to 30 feet), with wire size rated at 10 AWG. Longer extension cords require
larger size wire. If you are using the tool outdoors, use an extension cord rated for outdoor
use (signified by “WA” on the jacket).
21. Pacemaker safety warning. People with pacemakers should consult with their
physician(s) before using this product; operation of equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
Note: Performance of this tool may vary depending on variations in local line voltage. Exten-
sion cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Arc Welding Safety Warnings and Precautions
Warning: This product, when used for welding and similar applications, produces chemi-
cals known to the State of California to cause cancer and birth defects (or other repro-
ductive harm). California Health & Safety Code 25249.5, et seq.
1. Avoid electrical shock. Do not permit electrically live parts, cables, or electrodes to
contact skin, clothing, or gloves. Protective clothing should be free of holes, dry, and
ANSI approved.
This unit draws enough current to cause serious injury or death. Before turning the welder
on, check the electrode holder to be sure that there are no protruding screw heads, and
that all insulation is secure. Do not weld unless you are insulated from ground and the
work piece.
2. Avoid breathing fumes or gases. They can cause serious health problems. Use an
active ventilation system directly above the welding area. Keep your head out of the
fumes.
3. Avoid eye and body damage. Arc rays and infrared radiation can injure eyes and burn
skin. Wear ANSI approved eye and body protection. Do not allow viewing by visitors
without proper eye and body protection. Use a Face Shield with arc shaded filter plate.
4. Know proper arc welding practices. Read and understand this instruction manual, as
well as your employer’s safety practices for arc welding.
5. Connect only to a code approved power source. Connect only to a grounding power
source conforming to the National Electrical Code and Local Codes.