Filter
Top Products
SKU 65040 For technical questions, please call 1-800-444-3353. Page 5
The Sprayer is equipped with four
Spray Head (54, 55, 56, 58) types:
A. 30° Double Spray Head (54):
Designed for wider spray areas on
short crops and the spraying of
herbicides and pesticides. Move in
a parallel manner on one side while
spraying.
B. Fan Style Spray Head (55):
Sprays evenly. Suitable for spray
ing herbicides on short stalked
crops. Always spray in the same
direction as the wind.
C. Adjustable Spray Head (56):
Designed for spraying tall crops and
fruit trees and the spraying of
pesticides. However, the adjustable
spray head may result in signicant
overspray of pesticides.
D. Conical Spray Head (58):
May be used for spraying herbi-
cides and pesticides. Spray in the
same direction as the wind and on
one side, multi-row, cross spraying.
To attach a Spray Head (54, 55, 56, 2.
58), check to make sure the Spray
Head Sealing Ring (50) is properly
seated in the Spray Head Nut (53).
Screw the desired Spray Head into 3.
the Spray Head Nut.
To Fill The Container:
CAUTION!4. Always wear eye, breath-
ing, and skin protection. Wear ANSI-
approved safety impact goggles,
an ANSI approved respirator, latex
gloves, and proper safety clothing
when using this product.
Prior to lling the Tank (16) of the 5.
Sprayer with liquid, remove the Tank
Cap (23) and check to make sure the
Filter (21) is clear of dirt and debris.
If necessary, remove the Filter and
thoroughly clean.
Insert the Filter back into the opening 6.
of the Tank. Fill the Tank with up to
4 gallons of liquid. CAUTION! Do not
overll the Tank. Replace Tank Cap.
NOTE:7. The Sprayer is heavy when
completely lled with liquid. Always
get assistance when strapping the
Sprayer onto your body. If necessary,
adjust the Back Belt (43) for comfort.
Always make sure other adults, 8.
children, and animals do not have
access to the area(s) in which you
intend to chemically treat.
Grip Handle (30) of the Spray Gun 9.
assembly rmly with your right hand.
With your left hand, pump Arm (11) to 10.
build up sufcient pressure in Sprayer
system. Once the system is pressur-
ized (as indicated by an increased
tension on the Operation Arm), you
may stop pumping Arm.
Point the Spray Head (54, 55, 56, 11.
58) of the Spray Gun assembly to-
ward the area to be sprayed. Then,
squeeze the Lever (41) on the Spray
Gun assembly to begin spraying.
As you spray, the system will begin 12.
to depressurize. When distance of
spray diminishes you will need to
stop spraying momentarily. Resume
pumping Arm (11) to re-pressurize the
system before spraying again.
To rell Tank, squeeze the Lever to 13.
completely depressurize the system.