Filter
Top Products
SKU 66630 For technical questions, please call 1-800-444-3353. Page 17
To reduce possible injury should
kickback occur, stand to side of the
workpiece as it contacts the Blade.
WARNING! Do not stand in the line
of cut.
Once cut is made, turn off Table Saw. 6.
Wait for Blade to come to complete
stop before removing any part of
workpiece.
Making a Bevel Rip-cut
WARNING! 1. The Fence must be on
the right side of the Blade to avoid
trapping the wood and causing kick-
back. Placing the Fence to the left of
the Blade with result in kickback and
lead to potential injury and property
damage.
If ripping a piece larger than 36” long, 2.
place a support that is the same
height as the table behind the saw to
support the workpiece.
Keep wood clear of Blade before 3.
turning on Table Saw.
Position workpiece at on Table with 4.
the edge ush against the Fence. Let
Blade build up to full speed before
feeding workpiece into Blade.
Use Push Stick or push block to 5.
slowly feed workpiece toward the
Blade from the front.
WARNING! 6. Stand slightly to the side
of the wood to reduce chance of
injury.
Once Blade has made contact with 7.
the workpiece, use the hand closer to
Fence to guide it.
Make sure edge of workpiece re-8.
mains in solid contact with both
Fence and surface of Blade. If ripping
a narrow workpiece, use Push Stick
to move piece through cut and past
the Blade.
Once cut is made, turn off Table Saw. 9.
Wait for Blade to come to complete
stop before removing any part of
workpiece.
After the Blade has fully stopped, 10.
remove the cutoff stock.