Filter
Top Products
SKU 67046 For technical questions, please call 1-800-444-3353. Page 8
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
disconnect the tool from its
battery pack before
performing any inspection,
maintenance, or cleaning
procedures.
Press a sand paper sheet onto the
-
ing Pad (10).
Charge the Battery
The Charger (SKU 67031) and
Rechargeable Battery Pack (SKU
67029) are sold separately. Please
refer to the 67031 Charger manual
for important safety warnings and
proper instructions on charging tool.
WARNING! Do NOT use a different
Charger or Battery Pack to power this
tool.
General Operating Instructions
Attach the fully charged Battery Pack 1.
(sold separately) to the base of the
Sander.
To power the Sander for short bursts, 2.
press in and hold the Power Switch
(13), then release it to stop.
To lock the Power Switch on for con-3.
tinuous use:
Hold down the Power Switch (13), a.
Release the Power Switch, then b.
Turn off by depressing then releasing 4.
the Power Switch.
Sand the workpiece evenly with 5.
gentle, broad, sweeping strokes in a
crisscross pattern.
To prevent accidents, turn off the tool 6.
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children’s reach.