Filter
Top Products
Page 9
For technical questions, please call 1-800-444 3353.Item 67853
5. To start a cold engine, move the Choke to the CHOKE (start/
closed) position.
To restart a warm engine, leave the Choke in the
RUN position.
6. For MANUAL START
A. Turn the Engine Switch to ON.
B. Grip the Starter Handle of the Engine loosely and pull it
slowlyseveraltimestoallowthegasolinetoowintothe
Engine’s carburetor. Then pull the Starter Handle gently until
resistance is felt. Allow Cable to retract fully and then pull it
quickly. Repeat until the engine starts. Note: Do not let the
Starter Handle snap back against the engine. Hold it as it
recoils so it doesn't hit the engine.
7. Allow the Engine to run for several seconds. Then, if the
Choke lever is in the CHOKE position, move the Choke
Lever very slowly to its RUN position.
Note: Moving the Choke Lever too fast could kill the engine.
8. Close the Pilot Valve by rotating it to a horizontal position.
7
8
5
For ELECTRIC START
Turn the Engine Switch to START.
Note: To prolong starter life, use short starting cycles
(5 seconds maximum). Then wait one minute before
attempting to start again.
ON
OFF START
ON
ON
OFF START
START