Harbor Freight Tools 68126 Cordless Drill User Manual


 
Page 10For technical questions, please call 1-800-444-3353.SKU 68126
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Release the Trigger and remove
the Battery Pack before adjusting
tool or installing accessories.
BIT INSTALLATION:
CAUTION! Let bit cool before 1.
touching, changing or adjusting it.
Bits heat up dramatically while in use,
and can burn you.
Slide Direction Selector to its mid-2.
position.
While holding ring behind collar of 3.
Chuck with one hand, rotate collar
counterclockwise to open jaws.
Insert shank of drill bit or other accessory 4.
into chuck.
Turn collar clockwise to hand tighten. 5.
CAUTION! To prevent injury, do not
squeeze Trigger to release or tighten
chuck.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
Secure loose work pieces using a vise 2.
or clamps (not included) to prevent
movement while working.
There must not be objects, such as utility 3.
lines, nearby that will present a hazard
while working.
General Operating Instructions
Change Direction, Clutch, and Gear 1.
settings as desired, see page 8.
CAUTION: To prevent damage, do
not adjust any setting while drill is in
motion.
Install bit as explained to the left.2.
Insert Battery Pack into base of tool until 3.
it clicks in place.
Place tip of bit against desired location. 4.
Verify that work surface has no
hidden utility lines before drilling or
driving screws.
Place one hand over top of housing for 5.
greater tool stability. With other hand
grip handle and squeeze Trigger to
activate motor.
Do not force bit. Excessive force will 6.
damage tip and lead to tool failure.
Drill only as deep as needed.
To prevent accidents: After use, turn off 7.
the tool and remove the Battery Pack
by pressing on the striped side tabs and
sliding it out. Clean, then store the tool
indoors out of children’s reach.