Filter
Top Products
Page 8 For technical questions, please call 1-800-444-3353. SKU 68169
SPECIFICATIONS
Electrical
Input
120 V~ / 60 Hz / 7.5 A (Rated)
Motor Speed 0-2800 RPM
Drilling
Capacity
1/2” in Steel
5/8” in Masonry
1” in Wood
(Hammer Drill and Drill mode)
Chuck
Capacity
1/16” to 1/2”
Three Jaw Key Type
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
INSTRUCTIONS FOR PUTTING
INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn the Trigger
(32) off and unplug the tool from
its electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Assembly
1. Loosen the grip on the Side Handle
(46) and slide Side Handle clamp over
and behind the Chuck (3) until it is set
against housing.
2. Rotate the Side Handle until it is in
desired orientation. If you are right-
handed, position the Side Handle so it
extends from the left of the housing, as
shown Figure 1 above.
3. Rotate Side Handle clockwise to secure
the clamp.
4. To install the Depth Gauge (45), loosen
the Side Handle and slide the Depth
Gauge into the gauge hole. See Figure
1, above.
5. Set Depth Gauge to required depth and
retighten grip to fasten Depth Gauge
into place (read further explanation
under General Operating Instructions).
Figure 1
Chuck (3)
Side
Handle (46)
Depth Gauge (45)
Power Cord (35)
Key Holder