Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.Item 69234
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Adjust the Spring Tension
1. Pull out approximately six feet of Hose.
2. Remove the Hose Stopper from the
Hose and slide the Hose out of the Roller
Guide so the Hose is hanging loose.
a. To increase tension, wrap the loose hose
one time around the Reel Drum.
b. To decrease tension, unwrap the
hose one time from the drum.
3. Run the hose back through the guide
and re-attach the hose stopper.
4. Pull the Hose out several feet to check the tension.
General Operating Instructions
1. Check the Wheel operation by slowly pulling the
Hose out. You should hear a clicking noise.
2. To lock the Hose, pull it out a minimum
of 1/2 revolution and it will stay locked
after the first, second, or third click.
3. To unlock, slowly pull until the clicking stops, and let
it retract until the Hose Stopper hits the Hose Guide.
CAUTION: Hold on to the Hose while it is
rewinding, to avoid damage to the Hose Reel.
4. Attach a coupler (sold separately) to your
air compressor hose and apply thread
seal tape to the Inlet fitting on the Reel.
Connect the coupler to the Inlet fitting.
5. Connect your air tool to the other end of the Hose
using another coupler and thread seal tape.
6. Follow all instructions from the air tool
and compressor for set up and use.
7. When finished using the Hose, disconnect
the air tool and retract the hose. Wipe the
Hose Reel clean with a dry cloth.
SAFETYOPERATIONMAINTENANCE SETUP