Filter
Top Products
Page 6 For technical questions, please call 1-800-444-3353. Item 69234
User-Maintenance Instructions
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY:
Detach air supply from this product before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise, vibration,
or leaking air occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
Note: These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the Hose Reel.
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware or housing,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER EACH USE, re-wind the hose onto the reel
and wipe the Hose Reel clean with a dry cloth.
WARNING! Internal spring is not user-
serviceable or user-replaceable.
Hose Replacement
1. Remove the Hose Stopper from
the hose and set aside.
2. Pull out the old Hose and securely
lock the Hose Reel.
3. Disconnect the old hose from the swivel
joint and remove the hose.
4. Run the new hose through the Guide Roller
and through the opening in the drum flange.
5. Use thread seal tape on the hose fitting threads
and screw the fitting onto the swivel and tighten.
6. Attach the Hose Stopper on the end of
the Hose near the Outlet fitting.
7. Carefully release the Drum Latch and allow
the Hose to wind onto the reel, evenly
distributing the Hose across the Reel.
SAFETY OPERATION MAINTENANCESETUP