Filter
Top Products
Page 3SKU 90288
For technical questions, please call 1-800-444-3353.
in moving parts. Protective, electrically nonconductive clothes and nonskid
footwear are recommended when working. Wear restrictive hair covering to
contain long hair.
7. Use eye protection. Always wear ANSI approved impact safety goggles.
Wear a full face shield if you are producing metal lings or wood chips. Wear
an ANSI approved dust mask or respirator when working around metal, wood,
and chemical dusts and mists.
8. Do not overreach. Keep proper footing and balance at all times. Do not reach
over or across running machines.
9. Maintain tools with care. Keep tools clean for better and safer performance.
Follow instructions for changing accessories. Inspect tool periodically and if any
part appears broken or damaged, have it repaired by an authorized technician.
The handles must be kept clean, dry, and free from oil and grease at all times.
10. Disconnect power. Disconnect tool from air compressor when not in use.
11. Remove adjusting keys and wrenches. Check that adjusting wrenches are
removed from the tool or machine work surface before connecting it to its power
source.
12. Avoid unintentional starting. Be sure the air compressor switch is in the Off
position when not in use and before connecting to this tool. Do not carry any
tool with your nger on the trigger, whether it is plugged in or not.
13. Stay alert. Watch what you are doing, use common sense. Do not operate any
tool when you are tired.
14. Take caution as some woods contain preservatives such as copper chro-
mium arsenate (CCA) which can be toxic. When sanding these materials
extra care should be taken to avoid inhalation and minimize skin contact.
15. Check for damaged parts. Before using any tool, any part that appears dam-
aged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts;
any broken parts; and any other condition that may affect proper operation.
Any part that is damaged should be properly repaired or replaced by a qualied
technician. Do not use the tool if any switch does not turn On and Off properly.
16. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
17. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use ac-
cessories intended for use with this tool. Approved accessories are available
from Harbor Freight Tools.