Harbor Freight Tools 90374 Impact Driver User Manual


 
SKU 90374 PAGE 11
4. To charge the Battery (1A), plug the Battery Charger’s Plug (1B) into the Charging
Base (1C). Plug the Battery (1A) into the Charging Base (1C). Charging room
temperature: 50°
F - 104° F. Then, plug the Battery Charger into the nearest 120
Volt, grounded, electrical outlet. (See Figure D).
5. A
Charging Indicator Light
on the Charging Base (1C) will illuminate to show that
charging is taking place. NOTE: The Battery Charger (1B) will not automatically
turn off when the Battery is fully charged, and the Charging Indicator Light will
remain on until the Battery Charger is disconnected from the electrical outlet.
Recharging the Battery more than 5 hours can cause damage to the battery cells.
(See Figure D.)
6. While charging, the Battery (1A), Battery Charger (1B), and/or Charger Base (1C)
may become warm to the touch. This is normal, and does not indicate a problem.
(See Figure D.)
7. Once the Battery (1A) is fully charged, disconnect the Battery Charger (1B) from
the electrical outlet. Then, disconnect the Battery from the Charging Base.
(See Figure D.)
CHARGING BASE (1C)
BATTERY CHARGER (1B)
CHARGER PLUG
CHARGING INDICATOR LIGHT
PLUG BATTERY CHARGER
ONLY INTO A
120 VOLT, GROUNDED,
ELECTRICAL OUTLET.
FIGURE D
To Operate The Flashlight:
1. Insert the fully charged Battery (1A) in the Flashlight’s Handle, and make sure the
Spring
on the Battery snaps into place on the Handle.
(See Figure E, next page.)
2. Slide the Switch Button (4C) on the Handle forward to turn “ON”. (See Figure E.)
Note: Always switch to a fresh battery when tool performance
begins to diminish. Severe heat is most destructive to a battery; the
more heat generated, the faster the battery loses power. A battery that
gets too hot can be permanently damaged. Never over-discharge a
battery by using the tool even after tool performance is decreasing.
Never attempt to discharge a tool’s battery by continuing to pull the tool
trigger. When tool performance begins to diminish, stop the tool,
re-charge the battery and use the fresh battery for optimal
performance.
REV 03j, 04f, 07k