Filter
Top Products
SKU 91179 For technical questions, please call 1-800-444-3353. Page 3
6. Do not direct the Laser Beam into the eyes of any person or animal.
This may cause serious injury to the eye. Do not look directly into the beam
during operation.
7. Use the right tool for the job. There are certain applications for which this
product was designed. Do not modify this product and do not use this
product for a purpose for which it was not intended.
8. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired or distracted from the job at hand.
9. Check for damaged parts. Before using this product, carefully check that it
will operate properly and perform its intended function. Check for damaged
parts, loose parts, and any other conditions that may affect the operation of
this product. Do not disassemble the instrument or attempt to perform any
internal servicing. Repair and servicing of this Laser are to be performed
only by a qualified service technician.
10. Do not use this Laser if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not use this product.
11. Use only batteries of the type recommended-size “AA”. Do not mix old
and new batteries. Do not use different types of batteries. Do not use
rechargeable with alkaline batteries.
12. Make certain to switch the Laser button to the “OFF” position when
adjusting or when changing the batteries.
13. Remove batteries if the Laser is not used for a long period of time.
Note: Always switch to a fresh set of batteries when tool performance begins to
diminish. This is a delicate instrument. Do not drop or jar the Laser.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.