SKU 91852 For technical questions, please call 1-800-444-3353. PAGE 12
6.
Loosen
the Screw (57) that holds the Center Cover (56) in place. Then,
remove
the Screw (62). (See Figure F, next page.)
7. Rotate the Center Cover (56) up and out of the way.
(See Figure G, next page.)
FIGURE D
SAW BLADE (4)
ARROW
BLADE CASE (54)
ARROW
SAW TEETH
POINTING DOWNWARD
4. CAUTION! The Lock Pin (128) should always be activated in the
“locked down” position when the Saw is not being used and when the Saw
is being transported. The Lock Pin should be activated in the “locked up”
position when changing Saw Blades. NEVER use the Lock Pin in any
cutting operation. The Lock Pin allows the operator to lock the Saw Blade in
position, preventing the Saw Blade from being raised or lowered.
(See Figure E,
next page.)
5. Lock the Saw Blade (4) in its
upward
position. To do so, pull out on the Knob
(124). Raise and hold the body of the Miter Saw fully upward. Turn the Knob 90
degrees. Then, insert the Knob into the
deep
slot in its locked position.
(See Figure E.)