Harbor Freight Tools 91852 Saw User Manual


 
SKU 91852 For technical questions, please call 1-800-444-3353. PAGE 20
To Adjust The Angle Of Cut:
o
1. WARNING! Prior to performing this procedure, make sure the Power
Cord of the Miter Saw is unplugged from its electrical outlet.
2. The bevel angle (or Saw Blade
tilt
capacity) may be adjusted from 0 - 45
degrees to the left. To do so, loosen the Lock Lever (122) located at the rear of
the Miter Saw. (See Figure R.)
3. Tilt the Arm Holder (132) until the desired bevel angle of cut is achieved as indi-
cated on the Scale Plate (155). Then, retighten the Lock Lever (122) to lock
the Arm Holder in place. (See Figure R.)
FIGURE R
LOCK LEVER
(122)
SCALE PLATE
(155)
Basic Operation:
1. Make sure the Power Cord (27) of the Miter Saw is unplugged from its elec-
trical outlet. Then, if necessary, make adjustments to the workpiece Holder
(105), Baffle Plate (104), cutting depth, and miter angle and/or bevel angle.
2. Raise the Motor Housing (31) to its full “UP” position.
3. Check to make sure the Safety Button (37) and the Switch Lever (41) are operat-
ing properly.
4. Place the workpiece on the Work Table (87) and against the Guide Fence (97).
5. Use the Clamp Assembly (96, 99, 109, 111) to hold the workpiece in place.