Filter
Top Products
Skus
91053, 91054
For technical questions, please call 1-800-444-3353. Page 9
92147, & 92185
QUICK CONNECTOR (87)
WORK SURFACE
LOWER SAFETY (32)
TRIGGER (48)
EXHAUST COVER (3)
Operating the Nailer
1. Attach the Nailer to the air supply at the Quick Connector (87). Start your com-
pressor, and check the pressure making sure it is set at the recommended 75-125
PSI and not to go over the maximum PSI.
2. Rotate the Exhaust Cover (3) so that the exhaust air blast will be directed away
from the operator.
3. To fire, place the nose of the Nailer on the workpiece. The Nailer should not fire if
the nose is not depressed. Once depressed, gently and briefly squeeze the
Trigger (48) once. Do not fire repeatedly. Nails could bounce off of one an-
other, damaging the workpiece or causing PERSONAL INJURY.
4. Do not press the Lower Safety (32) of the Nailer against the work surface with
excessive force. Allow the tool to do the work. Always allow the tool to recoil off
the workpiece.
5. Caution: While working, dirt and sawdust may build up on the Lower Safety (32)
of the Nailer. This can prevent normal operation. Remove buildup using com-
pressed air.
6. When finished using the Nailer, always disconnect the tool from its compressed
air supply. Empty the Magazine (74) completely of nails. Attempt to fire the
Nailer into a piece of scrap wood to ensure it is disconnected and is incapable of
firing any nails.
7. Make sure to store the Nailer in its Carrying Case in a clean, dry, safe location
out of reach of children.
REV 11/06