Harbor Freight Tools 92703 Laser Level User Manual


 
Page 4 For technical questions, please call 1-800-444-3353. SKU 92703
Assembly
Remove the tripod from the case. 1.
Open tripod’s legs and adjust positioning 2.
of each leg until base is level. Use
bubble level in tripod base as a guide.
Remove the Laser Level from the case.3.
Install batteries, making sure to align 4.
batteries according to indicated polarity.
Attach the Laser to the tripod base. Do 5.
this by threading the bolt at the top of the
tripod through the holes at the center of
the Laser Level’s lower base.
Level the Laser by using the tri-brack 6.
adjustment screws until the bubbles are
centered on the two levels.
Loosen the brass screw located under 7.
the center of the Laser Level’s upper
base until the pendulum lock is released.
Turn on the Laser. Allow the laser lines 8.
to stabilize for 4 to 6 seconds before
starting any measuring or leveling tasks.
To disassemble and store, follow the 9.
above directions in reverse. Please
note: Retighten the brass screw under
the Laser Level before continuing. This
will lock down the pendulum during
disassembly.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn Power Switch
to Off before adjusting Level.
After removing the Laser from the 1.
Carrying Case, open the battery
compartment, insert the three “AA”
Batteries into the battery compartment
according to the polarity symbols
shown inside, and close the battery
compartment door.
Be sure to set the Laser on as at a 2.
surface as possible. The tri-brack
adjustment on the base of the level can
be used to help level the unit. (Turn each
of the knobs to either raise or lower that
corner.) The self-leveling range of the
Laser is within ±
. Use the 2 Vials on
the base to verify that the base is level.
Release the Pendulum Lock on the 3.
bottom of the Laser Level, by loosening
the Brass screw in the center.
Rev 05c, 05g, 07h