Filter
Top Products
Page 2 For technical questions, please call 1-800-444-3353. SKU 92841
SPECIFICATIONS
Operating Pressure
20 - 45 PSI,
50 PSI max.
Continuous Air
Consumption
5.5 to 9 SCFM
Recommended Hose
Diameter
1/4” I.D.
Net Weight 1.7 lb.
Body Construction
Cast Aluminum with
Aluminum Cup
Valve Construction Zinc Plated Brass
Air Inlet 1/4” NPS
Overall Dimensions
10-1/2”H x 7-1/2”L x
4-1/4”W
NOTE: This is a LVLP (Low Volume Low
Pressure) spray gun.
SAVE THIS MANUAL
You will need the manual for
the safety warnings and precautions,
assembly instructions, operating and
maintenance procedures, parts list and
diagram. Keep your invoice with this
manual. Write the invoice number on the
inside of the front cover. Keep the manual
and invoice in a safe and dry place for
future reference.
SAFETY WARNINGS AND
PRECAUTIONS
WARNING: When using tool, basic
safety precautions should always
be followed to reduce the risk of
personal injury and damage to
equipment.
Read all instructions before using this
tool!
Keep work area clean1. . Cluttered
areas invite injuries.
Observe work area conditions2. .
Do not use this sprayer in damp or
wet locations. Don’t expose to rain.
Keep work area well lit. Do not use
electrically powered compressors in
the presence of ammable gases or
liquids.
Keep children away3. . Children must
never be allowed in the work area.
Do not let them handle air lines,
machines, tools, or extension cords.
Store idle equipment4. . When not
in use, tools must be stored in a dry
location to inhibit rust. Always lock
up tools and keep out of reach of
children.
Use the right tool for the job5. . Do
not attempt to force a small tool or
attachment to do the work of a larger
industrial tool. There are certain
applications for which this tool was
designed. It will do the job better and
more safely at the rate for which it
was intended. Do not modify this tool
and do not use this tool for a purpose
for which it was not intended.
Dress properly6. . Protective,
electrically non-conductive
clothes and non-skid footwear are
recommended when working. Wear
restrictive hair covering to contain
long hair.
Use eye protection7. . Always wear
ANSI approved impact safety
goggles. Wear an ANSI approved
dust mask and respirator when
working around paint spray, chemical
dusts and mists.
Do not overreach8. . Keep proper
footing and balance at all times. Do
not reach over or across running
machines.
Maintain tools with care9. . Keep
tools maintained and clean for better
and safer performance. Follow
instructions for lubricating and
changing accessories. Inspect tool
REV 05d