Filter
Top Products
Page 11SKU 93431 For technical questions, please call 1-800-444-3353.
OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 13.
1. CAUTION: Always make sure the Power Cord (13) of the Sander is unplugged from
its electrical outlet
prior
to making any adjustments to the tool.
2. Clamp your workpiece down, or insert it in a vise. Make sure the wood you are
sanding does not have any nails or metal of any kind in it, or you will ruin the
sandpaper and damage the Backing Pad (23).
3. After donning the appropriate safety gear covered on page 5 of this manual, plug in
the Sander.
4. Turn on the Sander by turning on the Switch (15).
5. Always run the Sander for a few seconds before contacting the workpiece.
6. Contact the workpiece with minimal pressure. If the Sander is not removing enough
material, try a grittier piece of sandpaper. If you want to remove a lot of material fast,
use a belt sander.
Note: All orbital sanders leave sanding marks on the workpiece. To minimize sanding
marks, always try to sand with the grain of the wood.
7. Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.
8. When you are finished, turn off the Switch (15).
On/Off Switch (15)