Filter
Top Products
SKU 94434 For technical questions, please call 1-800-444-3353 PAGE 5
This is just an additional precaution; always check for hidden wiring before
drilling.
Do not use the Cordless Drill or Charger (26) if it has been dropped, damaged,
left outdoors, or immersed in liquid.
To avoid electrical shock, do not handle the Charger (26), its Power Cord Plug,
or the Cordless Drill with wet hands.
Keep the Handle of the Cordless Drill dry, clean, and free from oil and
grease.
Always turn off the Cordless Drill and unplug the Charger (26) from its electri-
cal outlet before changing accessories or performing any inspection, main-
tenance, or cleaning procedures.
Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Cordless Drill.
To avoid electrical shock, do not pull or carry the Charger (26) by its Power
Cord.
Never leave the Charger (26) unattended when it is plugged into an electrical
outlet. Make sure to unplug it from its electrical outlet before leaving.
Proper Battery Pack Care: Battery Pack (22) leakage may occur under extreme
usage or temperature conditions. If Battery Pack fluid comes in contact with skin,
wash with soap and water and rinse with lemon juice and vinegar. If the fluid comes
into contact with the eyes, flush with water for several minutes and contact a doctor
immediately. Never burn the Battery Pack, as it can explode in a fire. Do not charge
the Cordless Drill with a leaking Battery Pack. Contact local solid waste authorities
for instructions on correct disposal or recycling of the Battery Pack.
Use clamps (not included) or other practical ways to secure and support the
workpiece to a stable platform. Holding the work by hand or against your body
is unstable and may lead to loss of control.
Always switch to a fresh Battery Pack (22) when tool performance begins
to diminish. Severe heat is most destructive to a Battery Pack. The more heat
generated, the faster the Battery Pack loses power. A Battery Pack that gets too
hot can be permanently damaged. Never over-discharge a Battery Pack by using
the tool while tool performance is decreasing. Never attempt to discharge a tool’s
Battery Pack by continuing to pull the tool Trigger. When tool performance begins to
diminish, stop the tool, recharge the Battery Pack, and use the fresh Battery Pack
for optimal performance.
WARNING! Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California) to
cause cancer, birth defects or other reproductive harm. Some examples of these
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.