Filter
Top Products
Page 7For technical questions, please call 1-800-444-3353.SKU 94573
ASSEMBLY AND OPERATING
INSTRUCTIONS
CAUTION! Wear eye, breathing, and skin
protection. Wear ANSI-approved safety
impact goggles, a NIOSH-approved
respirator, latex gloves, and proper
safety clothing when using this product.
Nozzle Selection And Assembly:
The Sprayer is equipped with the 1.
following Nozzle types:
FIGURE F
30° DUAL NOZZLE
(60)
a. 30° Dual Nozzle (60): Designed
for wider spray areas on short crops
and the spraying of herbicides and
pesticides. Follow the wind and move
in a parallel manner on one side while
spraying. (See Figure F.)
FIGURE G
MIST
NOZZLE
(61)
b. Mist Nozzle (61): Designed for narrow
spray areas on low crops and the
spraying of herbicides and pesticides.
Follow the wind and move in a parallel
manner on one side while spraying.
(See Figure G.)
FOUR HOLE
ADJUSTABLE
NOZZLE (62)
FIGURE H
c. Four Hole Adjustable Nozzle (62):
Designed for spraying high crops
and fruit trees and the spraying of
pesticides. However, the Adjustable
Nozzle may result in signicant
overspray of pesticides.
(See Figure H.)
FIGURE I
CONICAL MIST
NOZZLE (65)
d. Conical Mist Nozzle (65): Designed
for spraying low crops and the spraying
of herbicides and pesticides. Allows for
a conical spray pattern. Follow the wind
and move in a parallel manner on one
side while spraying. (See Figure I.)
FIGURE J
NOZZLE
(60, 61, 62, 65)
NOZZLE
NUT (1)
SPRAY GUN ASSY.
NOZZLE GASKET
RING (4)
2. To attach a Nozzle (60, 61, 62, 65) to
the Spray Gun, check to make sure
the Nozzle Gasket Ring (4) is properly
seated in the Nozzle Nut (1). Then,
screw the desired Nozzle into the Nozzle
Nut. (See Figure J.)