Filter
Top Products
SKU 94849 For technical questions please call 1-800-444-3353 Page 6
Working with the Rechargeable Battery
Charging the Battery:
Batteries are normally shipped with low or no charge to prevent potential problems 1.
during shipment. Before use, you must charge your new Battery. Charge time is ap-
proximately 7-9 hours.
Plug the battery charger into a 120 VAC, 60 Hz power outlet. 2.
Insert the Battery into the charger by aligning the rib on the Battery with the groove 3.
in the charger. Press the Battery into place. The Red LED will illuminate indicating
that a Battery is charging.
The Red LED will remain on while the Battery charges. The Battery Charger will 4. not
automatically turn off when the Battery is fully charged. The charging indicator light
will remain on until the Battery Charger is disconnected from the electrical outlet.
Recharging the Battery more than 9 hours can cause damage to the Battery cells.
When the Battery is fully charged, remove the charged battery from the charger, and 5.
unplug the charger from its power source. Put the charger away for safekeeping. Do
not leave the Battery in the charger indenitely.
Always dispose of or recycle used batteries properly. Contact your local Hazardous 6.
Waste Authority for proper battery disposal guidelines.
Installing the Battery:
Slide the Battery into the base of the handle. 1. CAUTION: Do not press the battery
into the handle if it is not properly
aligned, as this may damage the
body of the tool, and will not secure
the battery.
Be sure the Battery is properly in-2.
stalled before using the tool.
Using the Battery Locks and Remov-
ing the Battery:
After placing the Battery in the tool, 1.
the battery locks on the side of the
Battery engage to prevent the battery
from coming out accidentally.
To remove the Battery, depress the 2.
locks and remove the Battery by pull-
ing straight out.
REV 08f