Filter
Top Products
SKU 94903 For technical questions please call 1-800-444-3353 Page 2
SPECIFICATIONS
Fuel Required Butane Torch Diameter 0.540” O.D. / 0.066” I.D.
Blade Temperature 500° F Igniter Piezo
This kit includes 5 soldering tips: Hot Knife, Pointed Tip, Slant Cut Tip, Cut Pointed
Tip and Rounded Tip.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instruc-
tions, operating and maintenance procedures, parts list and diagram. Keep your invoice
with this manual. Write the invoice number on the inside of the front cover. Keep the
manual and invoice in a safe and dry place for future reference.
SAFETY WARNINGS AND PRECAUTIONS
WARNING: When using tool, basic safety precautions should always be followed to reduce
the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
ONLY USE BUTANE FUEL. NEVER USE ANY OTHER FUEL IN THIS TOOL.
Keep work area clean. Cluttered areas invite injuries.
Observe work area conditions. Do not use machines or power tools in damp
or wet locations. Don’t expose to rain. Keep work area well lit. Do not use in the
presence of ammable gases or liquids.
Keep children away. Children must never be allowed in the work area. Do not let
them handle machines, tools, or extension cords. Children should never be allowed
to use this tool.
Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
Use the right tool for the job. Do not attempt to force a small tool or attachment
to do the work of a larger industrial tool. There are certain applications for which
this tool was designed. It will do the job better and more safely at the rate for which
it was intended. Do not modify this tool and do not use this tool for a purpose for
which it was not intended.
Dress properly. Do not wear ammable clothes. Do not wear loose or baggy
clothes. Protective, electrically non-conductive clothes and non-skid footwear are
recommended when working. Wear restrictive hair covering to contain long hair.
Heavy gloves should be worn to prevent burns.
Use eye and ear protection. Always wear ANSI-approved impact safety goggles.
Wear a full face shield since solder and other materials can splatter. Wear an ANSI
approved dust mask or respirator when working around metal, wood, and chemical
dusts and mists.
1.
2.
3.
4.
5.
6.
7.
8.