Filter
Top Products
SKU 95666 For technical questions, please call 1-800-444-3353 PAGE 9
OPERATING INSTRUCTIONS
1. WARNING! Always wear safety equipment. When operating the Impact
Wrench, always wear ANSI approved safety impact eye goggles, hearing protec-
tion, heavy duty work gloves, sturdy work boots, and head protection.
2. Select the desired size socket (not included) and firmly insert the socket onto the
1” Square Socket Drive (188D). (See Figure A.)
3. Place the Impact Wrench on a firm stand or solid floor.
4. Set the Gear Change Lever (233D) to its “NEUTRAL” position. (See Figure A.)
5. Slide the Stop Button (103) upward to its “START” position. (See Figure A.)
6. Move the Throttle Assembly (102) to its “IDLE” position. (See Figure A.)
7. Press the Primer (161.1C) several times to force fuel into the Engine’s Carbure-
tor. (See Figure A.)
8. Turn the Choke Lever (69) to its “CLOSED” position. (See Figure A.)
9. Pull sharply on the Recoil Starter (125B), and allow the Recoil Starter to return
to its original position. (See Figure A.)
13. WARNING! Before and during operation, always grip the Impact Wrench
with both hands to brace for Engine torque. Also, maintain a firm stance to keep
from slipping or falling down.
14. Insert the previously installed socket onto the bolt or nut that is to be loosened or
tightened.
15. Use the Gear Change Lever (233D) to select the desired rotation (forward/
reverse) of the tool. Select “R” for
clockwise
rotation or “L” for
counterclockwise
rotation. (See Figure A.)
12. After starting the Engine, allow the Engine about 2 to 3 minutes to warm up
before use.
11. NOTE: Should the Engine fail to start, repeat Steps #6 through #9.
10. Once the Engine starts, slowly return the Choke Lever (69) to its “OPEN” posi-
tion. (See Figure A.)