Filter
Top Products
SKU 95690-95692 For technical questions, please call 1-800-444-3353. PAGE 5
19. WARNING! The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
10. Dry running will cause damage to the inner seals. Make sure the water or
liquid chemical supply used for the Sprayer is not dirty or sandy.
11. Do not pull or carry the Sprayer by its Spray Gun Assembly. Use the Handle
on the Sprayer to move the tool from one location to another.
12. The work area should have adequate drainage to reduce the possibility of
a fall due to slippery surfaces.
13. This product is designed for outdoor use only.
14. Keep the Cap and Spray Gun Assembly of the Sprayer connected to the
tool while the system is pressurized. Prior to refilling or emptying the Tank,
pull up on the Pressure Release Valve to completely depressurize the
system.
15. Prior to starting the Sprayer in cold weather, check all of the parts of the
tool to make sure ice has not formed. Do not store the Sprayer where the
temperature will fall below 32° Fahrenheit.
16. Do not keep water or any liquid chemicals in the Sprayer after use.
17. Make sure to clean the Filter of the Sprayer before each use.
18. Never leave the Sprayer unattended. When finished using the Sprayer, empty
the unit. Thoroughly clean the unit and store it in a clean, dry, safe location out
of reach of children.
OPERATING INSTRUCTIONS
To Fill The Container (31):
1. CAUTION! Always wear eye, breathing, and skin protection. Wear ANSI
approved safety impact goggles, an ANSI approved respirator, latex gloves, and
proper safety clothing when using this product.
2. Prior to filling the Container (31) of the Sprayer with liquid, pull up on the Safety
Release Valve (20) to release any pressure within the Container.
(See Figure A, next page.)