Filter
Top Products
SKU 95690-95692 For technical questions, please call 1-800-444-3353. PAGE 7
10. As you spray, the system will begin to depressurize. When the distance of the
spray diminishes you will need to stop spraying momentarily. Then, resume
pumping the Pump Handle (43) to re-pressurize the system before spraying
again. (See Figure A.)
11. If it becomes necessary to refill the Container (31) of the Sprayer, pull up on the
Safety Release Valve (20) to completely de-pressurize the system. Remove the
Pump Handle (43) from the Container. Refill the Container with liquid, and re-
place the Pump Handle. Pump the Pump Handle to pressurize the system, and
continue spraying. (See Figure A.)
12. When finished spraying, de-pressurize the system by pulling up on the Safety
Release Valve (20). Remove the Pump Handle (43) from the Container (31) and
empty any remaining liquid into a safe and secure container. Clean the Sprayer
thoroughly with agents recommended by the chemical manufacturer. Allow the
unit to air-dry. Replace the Pump Handle, and store the Sprayer in a clean, dry,
safe location out of reach of children. (See Figure A.)
9. NOTE: For a continuous spray mode, press the Lever (8) forward and down to
its locked position. Then release your grip on the Lever. To stop the continuous
spray mode, press down, then let up on the Lever. (See Figure C.)
FIGURE C
LEVER
(8)
LEVER
(8)
1. CAUTION! Always de-pressurize the system by pulling up on the
Safety Release Valve (20) before performing any inspection, maintenance,
or cleaning of the Sprayer.
2. Before each use, inspect the general condition of the Sprayer. Check for
misalignment or binding of moving parts, damaged or loose parts, dirt or debris
in the Nozzle, and any other condition that may affect the tool’s safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further
use. Do not use damaged equipment.
INSPECTION, MAINTENANCE, AND CLEANING
3. Periodically, lubricate all moving parts of the Pump Handle (43) assembly.