Filter
Top Products
Page 6
SKU 96445
For technical questions, please call 1-800-444-3353
REV 07h
INSPECTION, MAINTENANCE AND CLEANING
Make sure your Palm Grip Sander is disconnected from the air hose before attempting
any maintenance.
Wipe the Palm Grip Sander down with a lint free cloth after each use.
If you do not use an inline oiler/filter system, lubricate the tool daily by holding it so that
the Valve (12) is facing up. Squeeze the Trigger (1), and place one or two drops of oil
into the Valve (12). Squeezing the Trigger (1) allows the oil to circulate in the motor.
Store in a safe and dry location out of the reach of children.
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Tool will not operate Low or no air pressure
Corroded Rotor
Damaged Seals or O-Rings
1.
2.
3.
Check air compressor to be sure
it is operating properly. Check air
regulator. Check air lines for leaking
or blockage.
Spray light weight penetrating
oil into the regulator. If tool still
won’t operate, take it to a qualified
service technician for repair.
Take it to a qualified service
technician for repair.
1.
2.
3.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUY-
ER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
1.
2.
3.
4.