Filter
Top Products
Page 10SKU 97719 For technical questions, please call 1-800-444-3353.
Power Cord Plug. Never remove the
grounding prong or modify the Power
Cord Plug in any way. Do not use
adapter plugs with this product.
To assemble the two Wheels (9), 3.
insert the Axle (8) through the two
holes located at the bottom/rear of the
Base Frame (3). Place the Wheels
onto the protruding ends of the Axle.
Then secrure the Wheels in place,
using one Bolt (10) for each end of
the Axle. (See Assy. Diagram.)
To attach the Handle (30), align the 4.
two holes in the Handle with the two
threaded mounting holes located
at the top of the Case (28). Secure
the Handle to the Case, using two
Screws (31). (See Assy. Diagram.)
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS
INJURY FROM ACCIDENTAL
OPERATION:
Turn the switch to its off
position before performing
any inspection, maintenance,
or cleaning procedures.
Workpiece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the Power Cord (32) along a 2.
safe route to reach the work area
without creating a tripping hazard or
exposing the power cord to possible
damage. The power cord must reach
the work area with enough extra
length to allow free movement while
working.
Secure loose workpieces using a vise 3.
or clamps (not included) to prevent
movement while working. The work-
pieces should be rmly held together
and in position while welding. The
distance (if any) between the two
workpieces must be controlled
properly to allow the weld to hold both
sides securely while allowing the weld
to penetrate fully into the joint.
There must not be hazardous objects, 4.
such as utility lines or foreign objects,
nearby that will present a hazard
while working.
A barrier, such as a welding curtain 5.
or welding shroud, should be put up
to protect others in the work area and
limit the spray of sparks.