Filter
Top Products
Page 9SKU 98199 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Motor
120 V~ / 60 Hz / 15 A
n
0
5300/min
Arbor Diameter 5/8”
Blade Type
General Purpose with
Carbide Tips
Blade Diameter 10”
Cutting Capacity
At 90°: 2-3/4” Deep x 12”
Wide. At 45° 1-9/16” Deep
x 8-1/4” Wide.
Positive Table Stops
0°, 15°, 22.5°, 30° and
45° Right and Left
Positive Bevel Stops 0° and 45° Left only
Blade Tilt Range
0° - 45° Right and Left
Miter
0° - 45° left
Scale 1° per scale mark
E105017
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
List of contents
Description Qty
Compound Sliding Miter Saw 1
Carbide Tipped Blade 1
Table Extensions 2
Dust Collection Bag 1
Wrench 1
INITIAL SET UP
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Attaching the Extension Supports and
Miter Lock Handle
Insert the ends of the Extension 1.
Supports into the holes in the sides
of the Base. Tighten the Wing Screws
to hold the Extensions in place. The
upper edge of the Extensions will be
level with the surface of the saw. This
provides a wider base for the work
material to rest on.
Thread the Miter Lock Handle into the 2.
Plate until securely in place.
Attaching the Dust Collection Bag
The Dust Collection Bag slips over 3.
the Dust Outlet behind the Blade
Housing Assembly. Sawdust created
by cutting is captured in the bag.
WARNING