Filter
Top Products
Page 10SKU 42818
7. Remove the existing Saw Blade and replace with another 12 inch blade.
The new Saw Blade has an arrow on it that must be pointing in the same direction as
the large arrow on the outside of the Blade Case (31).
Caution: Never use saw blades larger or smaller in diameter than 12 inches, and rated
less than 5000 RPM operation.
8. Replace the Outer Flange (82) and Hex Flange Bolt (83).
9. Press in on the Spindle Lock button and retighten the Bolt in a counterclockwise
direction with the socket wrench.
10. Replace the Safety Cover to its original position and retighten the Hex Bolt (A).
11. Press down on the saw Handle and verify that the safety Shield moves back properly,
and that the blade does not touch the Fence or Table.
Socket Wrench
Hex Flange Bolt (83)
Shaft Lock Button
Maintenance
Replacing the Motor Brushes
It may become necessary at sometime to replace the motor brushes when the motor perfor-
mance decreases, or stops working completely. The following steps describe their replace-
ment. This procedure should be done by a qualified technician.
1. Unplug the Power Cord Plug from the electrical outlet.
2. Remove the Brush Holder Caps (14) and Carbon Brushes (13) from the Motor
Housing (16).
Examine the Carbon Brushes. If the they are worn past 3/16 inch in length, or if the
spring or shunt wires are burnt, they must be replaced. Never replace just one brush. If
the brushes are only dirty, and not worn down, you can use a pencil eraser to clean
the brush tips.
3. Replace the Carbon Brushes (13) and Brush Holder Caps (14) .
4. Connect the Power Cord to an electrical outlet and test the saw’s operation.